1.What information can be found in the NonStop S-series Fastpath Guide? A: CRU replacement proceduresB: AWAN configuration informationC: system configuration file contentsD: system installation checklistCorrect Answers:  D 2.The OSS file system resolves all OSS pathnames using an OSS server called the _______. A: OSS file managerB: OSS path serverC: OSS monitorD: OSS name serverCorrect Answers:  D 3.What is the name of the basic startup file that comes with a NonStop S-series system? A: PATHSTARTB: OBEYC: CIIND: STARTUPCorrect Answers:  C 4.You are adding an I/O enclosure online.  The new enclosure needs to have the same _______.  Select  TWO. A:number of SEBs as the group 02 enclosureB:topology configured as the system to which it is being addedC:number of disk drives as the group 01 enclosureD:firmware as the system to which it is being addedE:number of adapters as the other enclosures in the system to which it is being addedCorrect Answers:  B, D 5.Which utilities are used to configure a ServerNet wide area network (SWAN) concentrator?  Select TWO. A:SCFB:FUPC:WAN Wizard ProD:NSKCOME:TSMCorrect Answers:  A, C 6.Which of the following are valid Tetra8 configurations?  Select THREE. A:six processors and two I/O enclosures per processor enclosureB:eight processors and three I/O enclosures per processor enclosureC:four processors and one I/O enclosure per processor enclosureD:ten processors and one I/O enclosures per processor enclosureE:two processors and no I/O enclosuresF:one processor and two I/O enclosuresG:four processors and three I/O enclosures per processor enclosureCorrect Answers:  A, C, E 7.Increasing the number of disk processes per logical volume _______. A: provides fault toleranceB: decreases memory usage while not affecting disk I/O performanceC: increases memory usage and improves disk I/O performanceD: decreases memory usage and improves disk I/O performanceCorrect Answers:  C 8.What available references would define the initial IP addresses set at the factory for Master Service Processor (MSP) and the TSM service application?  Select TWO. A:SN 97066B:NonStop S-series Fastpath GuideC:TCP/IP Management Programming ManualD:TSM Configuration GuideE:TCP/IP Configuration and Management ManualCorrect Answers:  B, D 9.Which statement concerning master service processors is true? A: They provide the connection to the system console.B: They are located in group 0.C: They perform system reload functions.D: They are used to dump the memory of other service processors.Correct Answers:  A 10.Which factor is LEAST likely to be a cause of poor system performance? A: high processor busy timeB: high disk I/O rateC: high memory swap rateD: high disk cache hit rateCorrect Answers:  D