1.Click the Task button. Place the steps for installing the MSA1000 in the correct order.Drag and drop question. Drag the items to the proper locations.Correct Answers:2.Click the Task button. Categorize the Secure Path and Secure Path Manager features.Drag and drop question. Drag the items to the proper locations.Correct Answers:3.A customer installed a Linux cluster and a NetWare cluster attached to a fully redundant MSA1000 subsystem using Secure Path. The customer tested Secure Path on the Linux cluster and found it does not fail over to the standby controller. Which two would cause this to happen? (Choose two.)A:Zoning is configured incorrectly.B:Secure Path is not installed correctly on the NetWare cluster.C:NetWare and Linux are connected to the same MSA1000 subsystem.D:The customer enabled Selective Storage Presentation (SSP)but did not specify appropriate host mode on Linux connections.Correct Answers:  A, D 4.A customer network contains 15 windows hosts. Five hosts are connected to a SAN, which contains two Brocade 2/16 switches. Where is Secure Path Manager installed in this SAN? A: on the switchesB: on the MSA1000C: on the host on the SAND: on any host on the networkCorrect Answers:  D 5.What is used to launch Secure Path Manager? A: http://localhost:2381B: http://localhost:7902C: StorageWorks Command Console clientD: Secure Path Manager local program groupCorrect Answers:  A 6.From which three sources can you obtain the Array Diagnostics Utility (ADU)? (Choose three.) A:HP websiteB:MSA Support CDC:HP Smart Start CDD:HP Management CDE:Secure Path Manager CDCorrect Answers:  A, B, C 7.Click the Exhibit button. What does blinking green on the enclosure status LED number 1 indicate?A: EMU is operating normally.B: MSA is operating at 1 Gb/s.C: MSA is operating at 2 Gb/s.D: EMU is NOT operating normally.Correct Answers:  A 8.Using the MSA1000 Command Line Interface, which command is used to set up Selective Storage Presentation (SSP) for LUN 1 with connection ABC? A: SET UNIT 1 ENABLE=ABCB: SSP UNIT 1 ENABLE=ABCC: ADD ACL CONNECTION=ABC UNIT=1D: SET ACL CONNECTION=ABC UNIT=1Correct Answers:  C 9.What are two possible reasons a Secure Path profile is unable to connect to the target host? (Choose two.) A:The DNS server is unreachable or not defined.B:The SWCC console agent service is not started.C:The Secure Path Agent is set for local only access.D:The host's file does not contain an entry for the server.Correct Answers:  A, D 10.How many total device-side SCSI buses are there in the MSA1500 cs controller when attached to the MSA20 enclosures? A: 2B: 4C: 6D: 8Correct Answers:  D