1.Click the Task button. Click on the Fibre Channel pass-through ports for side B.Hotspot question. Click on the correct location or locations in the exhibit.Correct Answers:2.Click the Task button.  Click on the external 10/100/1000BaseT Ethernet ports for side A.Hotspot question. Click on the correct location or locations in the exhibit.Correct Answers:3.Which ambient air direction is used by the HP BladeSystem for cooling? A: front-to-backB: back-to-frontC: top-to-bottomD: bottom-to-topCorrect Answers:  A 4.You connect a fully-populated ProLiant BL40p blade server to the Diagnostic Station. When you attempt to power on the blade server, it does not turn on. Why? A: ProLiant BL40p blade servers are not supported with the Diagnostic Station.B: Two Diagnostic Stations are required to power the ProLiant BL40p blade servers.C: You did not use the dual-power input kit.D: You used a single power supply in the Diagnostic Station instead of two.Correct Answers:  D 5.You have an enhanced blade server enclosure connected to a single 3U power enclosure. Only side A of the blade server enclosure is connected to the power enclosure. Which blade server enclosure bays receive DC power? A: bays 1 through 4, plus the interconnect bay on side AB: bays 1 through 8C: bays 1 through 8, plus the interconnect baysD: bays 1 through 4, plus the interconnect baysE: bays 5 through 8, plus the interconnect bay on side ACorrect Answers:  D 6.You have an Integrity BL60p blade server with internal disk drives installed in the enhanced blade server enclosure. One of the disk drives failed, but the Failure LED is not illuminated. Why? A: The Failure LED illuminates only if using HP-branded disk drives.B: The Failure LED is not supported by HP-UX.C: The appropriate management functionality is not enabled in the EFI.D: The appropriate HP-UX management device drivers have not been loaded.E: The enhanced blade server enclosure firmware must be version 2.30 or later.Correct Answers:  B 7.Which HP SIM plug-in component enables scanning for and patching of network vulnerabilities? A: PIMB: PMPC: VMMD: VPMCorrect Answers:  D 8.After deploying a ProLiant BL35p blade server with RDP, the blade server is operating normally. However, you lose the capability to remotely manage the blade server using the Deployment Server Console. Why? A: The administrator password is not set for the HP Insight Management Agents.B: The Deployment Server Agent is not installed or failed to start.C: The Deployment Server is out of valid iLO Advanced licenses.D: The "Synchronize display names with Windows computer names" option is not set.Correct Answers:  B 9.You have a fully populated enhanced blade server enclosure. You connect to the blade server in bay 3 using the local I/O cable. You can navigate through the iLO of the local blade server, but not the other blade servers. Why? A: The management module on the back of the blade server enclosure is incorrectly configured.B: The front blade server port connection limits access to the blade server it is connected to.C: The power enclosure and the blade server enclosure management ports are not cabled or cabled incorrectly.D: The iLO Advanced firmware is older than version 1.64.Correct Answers:  B 10.When accessing the iLO BL p-Class tab, you receive the "Unable to collect rack data" error message. Why? Select TWO. A:You have not yet licensed all blade server iLOs.B:At least one power enclosure or blade server enclosure does not meet the minimum firmware requirements.C:A DHCP server exists on the network and conflicts with the Static IP Bay Configuration feature.D:At least one blade server iLO is not configured.E:At least one management module has mismatched firmware.Correct Answers:  B, E